IS-IS for FabricPath
Hi all,Lets say we have two data center locations and one remote location and MPLS VRF configured between the data centers and the remote location. We use IS-IS as the IGP. Now we want to run...
View ArticleClik here to view.
Invitation to connect on LinkedIn
From Alberto Mounguengui Sr.Network Architect at General DatatechGreater Chicago Area I'd like to add you to my professional network on LinkedIn. - Alberto Confirm that you know...
View ArticleCCIE Voice to become new CCIE in Nov '13
See my blog article for more news, and also see comments for further insight.
View Articlevol 2 lab 2
I've freshly loaded vol 2 lab2 and sw1 and bb3 are giving a as mismatch message. I've checked the config on SW1 shows BB3 nei as as 54, which is correct. Could someone point me in the right...
View ArticleClik here to view.
Documentation link for 3560 QOS
Although I have understood the 3560 Egress/Ingress Queuing to the best of my ability, I am pretty sure knowing my way around the documentation for this part might be a key in case of facing some tricky...
View Articleticket 5 - alternative solution
Configured "allow-as in" on R1 should do the same trick. Rack1R1#sh ip bgp Network Next Hop Metric LocPrf Weight Path* 40.1.0.0/21 40.1.15.5...
View Articlemls qos
Hi Guys, I am ccie from this forum, i am doing qos for a voip (lync) project and struggleing with the mls qos LAN side of the qos, I would like to reserve 10% of the link ( edge dis core) for voip...
View Articleshape peak with shape adaptive
Hi all I have a question when using shape adaptive with shape peak do we set adaptive to be half our minimum rate becuase peak shaping uses both the Bc and Be per interval? Eg: policy-map shape-all...
View ArticleClik here to view.
Site-to-Site IPsec VPN not working - Need help Verifying Configs
Hello community,I have configured Site-to-Site IPsec VPN as per the topology shown here but for some reason my routers are not negotiating Phase1 or Phase2. I have checked my configs multiple times...
View Article"CCIE Data Center Full Scale Labs (Beta)" Rack Rental?
Hello all,I am preparing to take my lab in August and I have been using the VOD as well as the workbook. I am looking to try the CCIE DC Full Scale Lab workbook. I was looking at the topology for this...
View ArticleN5k to N2k
Little confsue ..suppose N2k is connected to Rack Mount server which has CNA 2nd Gen. topology is exhibited below-- Rack Server -- N2k (Cisco Nexus 2232PP) --- N5k -- MDS--Storage. NOW from CNA to...
View ArticleUCS 2.0
I have heared this statement multiple time " UCS2.0 Does not support Northound FCOE " , does it mean FI to N5K to MDS to Storage we can't have Multihop FCOE .Is UCS 2.1 support Northbound FCOE , if so...
View ArticleUCSM ACCESS PROBLEM IN INE RACK RENTAL
Hi All,I had a session some days ago and I could not access the UCS via the Virtual IP given in the workbook(i.e. 192.168.0.100). Is there any seeting we need to do in order to access the UCSM in the...
View ArticleNeed studymate
Hi, I need studymate for my CCIE R&S Lab stud. I will seat for CCIE lab in Dec this year. Thank You.
View Articlebgp synchronisation
hithe rule say If your autonomous system is passing traffic from another AS to a third AS, BGP should not advertise a route before all routers in your AS have learned about the route via IGP.does mean...
View ArticleVOL2 TS1
Guys,I was doing the VOL2 TS1 when I've seen the question below : Resolve the problem preventing R4 from reaching SW2 over the shortestpath R4 couldn't reach SW4 and be ospf neighbor , because the dead...
View ArticleIpsec tunnel reset
This is a production related issue. I want to reset IPsec VPN tunnel with a specific peer. We've 50+ VPN peers and don't want to impact any other peers except one. I want to reset the tunnel...
View Article7.47 AS300 still transiting traffic between AS200 and AS100
Part of this task is prevent AS300 transiting traffict to/from AS200 and AS100. However AS300 is inadvertently used for transit as the the next hop 155.x.45.4 recurses to R3 f0/0 with a next hop of...
View ArticleCE to Managed-CE e-BGP peering for multiple services
Guys; Another advice that i seek from you guys. So now i have a CE device connecting to our Managed customer facing node taht i call managed-CE. I have two vrfs on managed-CE, vrf-SERVICE-1 and...
View ArticleUpgrading my lab/getting ready for the CCIE
Hey,So i'm starting to upgrade my lab and i was hopping to get suggestions on what to buy or rather what would be a better buy:So as of writing this i have:1x 2511-RJ (access server)1x 2611XM w/ nm-8as...
View Article