UCS CIMC/IPMI/KVM
Hi guys,I was wondering if anybody can help me understand CIMC and IPMI properly? How does KVM work and what does it use? What does management IP address in Service Profile apply to?Regards,AB
View ArticleiSCSI Boot
Hi, Just wondering can we do UCS boot from iSCSI , topology looks like UCS---FI--FC Link---MDS---FC Link---JBOD ... please suggest !!
View ArticleEIGRP Router-ID problem on External Route
Hi,Please see the link below. I was putting a lab together for testing, and basically R2 receives the external eigrp route for 34.34.34.0/24, but R1 doesn't. The problem was the originating router-id...
View ArticleTask 5.4 - r4 & r5 receives no mroute and rp info
Does anyone able to receive RP information on R4 and R5? I know the task didn't ask to check for RP but if it is working, we should see RP on R4 & R5.In addition, to make the IPv6 static route for...
View Articlehow to flush route profile
Hello Folks, On a routing table, some prefixes are withdrawed and installed back and forth, over and over again, several times per second. I know to address this routing issue, but I would like to...
View ArticleTask 7.1 Thresholds
Since questions is asking When there are more than 750 packets in the output queue, R1 should generate the message “WARNING: Frame Relay Circuit Congested”.SG looks good as it has to rise above...
View ArticleSP Lab 1st attempt failed
Took the SP Lab in RTP yesterday and things did not go well.First off at the very start of the exam was a troubleshooting step to get some IGP working. I fixed up obvious errors but ran into two XR...
View ArticleQOS on Fa0/0 interface [ internet & MPLS traffic ]
Hi Experts,Need your suggestions:Scenarion ====== LAN 100 MB | Router | WAN======= 8 MB [ 4MB & 4 MB MPLS Tunnel ]I have a connection to ISP with 8 MB bandwidth , 4 MB is internet and 4 MB mpls...
View ArticleThoughts on pre-configuration analysis approach
If anyone is willing to share, I'd like to hear other people's thoughts on the best way, or good ways, to approach the pre-configuration analysis when doing a lab. If anyone isn't familiar with what...
View ArticleTask 2.3 Default routing - solution incomplete
Task asks us to have R3 originate a default route into OSPF as long as it has an active connection to either BB2 or BB3. The solutions guide used a route-map which checked for the presence of the...
View ArticleOSPFv2 LFA Fast Reroute
All,I was wondering if anyone has successfully setup either OSPFv2 Loop Free Alternate Fast Reroute (single or multi-hop) in GNS3. It's part of the RS v5 Lab Topics and need to test it out. If yes,...
View ArticleTask 3.3 - Bridging over FR
Did anybody else run into an issue here? I configured it as I knew how to, looked at the SG and it was the same, but can't get the interface to pass traffic. It looks like it's going out, and appears...
View ArticleTask 3.3 potnetail solution
Does anyone see a problem with this as a solution. Trying to think why this would be a problem and i can't...bridge irbbridge 1 protocol ieeebridge 1 route ip!interface Serial0/0/0encapsulation...
View ArticleCSC technology
Just started going through this and i can't shrug off the feeling that it is seems bit odd design in the real world, I would imagine most people would rather purchase a L2 service from the backbone...
View ArticleClik here to view.
Michael Marx, CCIE #42713 (R/S)
My apologies for the length, but I have imagined writing this post for about a year now. I am sure it littered with typos - btu now its too long to proof... Frequently while I was studying I would...
View ArticleOutgoing Label - No Label
Watching the Basic MPLS config video and see a phrase of "no label" in the mpls forwarding-table. This is seen when the destination is reached via an interface that is not running mpls. First question...
View Article14.3 - MPLS Label Filtering
Hi, This task saysConfigure R4, R5 and R6 so that the only labels advertised by LDP are the ones for the Looback 0 interfaces of the mentioned routers.The SG permits the whole loopback range...
View ArticleWill IS-IS and multicast be soon obsolete ?
Will IS-IS and multicast be soon obsolete ??? as I am learning these technologies and want to know that these technologies will be used for sometime .
View ArticleVPLS - Transport-mode ethernet vs Transport-mode vlan
Hi everybody,it is nice to write in this blog again. After a period far away from intensive configs i am up again to prepare my lab exam just a few weeks away. After doing Lab 1 , 2 and 3 with no...
View ArticleNeed Help with Task 4.1 on SP Full Scale Lab 4
Hi All,I am running into a problem on Task 4.1 on Full Scale Lab 4. I've spent hours on this and can't figure this one out. The short story is that during this task, R5 is not able to learn labels...
View Article